MTD 45-01763 - Manual (Page 3)

3. Turn the front angle assembly and bottom panel
upside down as shown In figure 3.
4. Lay the two side angles on the bottom panel so
that the two holes for the axle clamps are closer to
the front angle assembly. See figure 3.
5. Secure both axle clamps to the side angles and
the bottom panel using four 1/4" x 1-1/4" screws,
lock washers and hex nuts. Make only finger
tight until axle is assembled. See figure 3.
6. Secure both side angle assemblies to the bottom
panel using four 1 /4" x 1" screws, flat washers and
hex nuts. Make only finger tight until all four screws
are in place, then tighten securely. See figure 4.
7, Stand the cart on Its front end with the front angle
assembly on the floor. See figure 5.
8. Temporarily place four large 1>1/2" flat washers
(used on wheel axle) on the Inside of front angle
assembly. See figure 5.
NOTE
These washers act as shims and are
Just for assembly purposes. You will
remove them later to use on axle.
9. Lay the front panel down onto the front angle
assembly, on top of the four large washers. See
figure 6.