Maintenance – MTD 45-01763 User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
20. Assemble a cotter pin to the Inside hole at one end
of the axle. Place a 1-1/2” flat washer, a wheel and
then another 1-1/2" fiat washer onto the axle.
Secure the wheel with a cotter pin assembled to
the outside hole at the end of the axle. Repeat
step for other wheel. See figure 12.
21, Center the wheels and the axle side to side.
Tighten the four nuts on the axle clamps.
MAINTENANCE
1. Grease or oil wheel bearings occasionally. Use
automotive wheel bearing type grease or 20 weight
oil.
2. Periodically retIghten all screws, especlaiiy after
heavy use. Do not exceed load capacity rating
of 300 lbs.
3. Clean cart thoroughly after each use.
4. Store Indoors during severe weather,
5. Apply light coat of varnish to all wood surfaces
annually.
6. Use glossy biack enamel spray paint to touch up
scratched or worn painted metal surfaces.
RECOMMENDED TIRE PRESSURE 35-40 PSI
MAXIMUM TIRE PRESSURE 40 PSI
22. Turn cart right side up, so that it rests on Its
wheels.
23. Place front panel in guides to complete assembly.
24. Your cart Is now ready to use.