MTD 45-01763 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
15, Lay the cart down on the floor so that the sides are
up in a normal position. Remove the front panel by
sliding It up, then remove the four large washers
you used for shims. See figure 9.
16. Stand cart up on Its front end again. Place tube
caps on leg tube and assemble the leg tube as
shown In figure 10, using four 1/4" x 2" screws
through side panels and teg tube. Secure with flat
washers and hex nuts. See figure 10.
17. Leave the cart standing to assemble the handle
tube in the next step.
16. Place tube caps on the handle tube, then place it
over the side panels and line up the four holes.
Assemble four 1/4" x 2" screws through the side
panels and handle. Secure with flat washers and
hex nuts. See figure 11.
SIDE PANEL
FIGURE 11
19. Lay the cart upside down. Slide the axle through
the axle clamps. See figure 12.
FIGURE 12