Cisco WRTP54G - Manual (Page 38)

Wireless-G Broadband Router with 2 Phone Ports
30 Chapter 5: Configuring the Router
The Wireless Tab - Wireless MAC Filter
The Wireless Tab - Wireless MAC Filter
Wireless MAC Filter
Wireless MAC Filter. If you want to filter wireless access by MAC address, select Enable. Otherwise, select
Disable.
Click Prevent to block access for the designated computers, or click Permit only to permit access for the
designated computers. Click the Update Filter List button, and the Mac Address Filter List screen will appear.
Enter the MAC addresses of the computers you want to designate. To see a list of MAC addresses for wireless
computers or clients, click the Wireless Client MAC List button.
The Wireless Client MAC List screen will list Client Host Names, IP Addresses, and MAC Addresses for your
wireless devices. Click the Refresh button to get the most up-to-date information. To add a specific computer to
the Mac Address Filter List, click the Enable MAC Filter checkbox and then the Update Filter List button. Click
the Close button to return to the MAC Address Filter List screen.
On the MAC Address Filter List screen, click the Save Settings button to save this list, or click the Cancel
Changes button to remove your entries.
When finished making your changes on this tab, click the Save Settings button to save these changes, or click
the Cancel Changes button to undo your changes.
Figure 5-16: Wireless Tab - Wireless
MAC Filter
Figure 5-18: Wireless Client MAC List
Figure 5-17: MAC Address Filter List