Audiovox DVD-220 - Manual (Page 8)

G. BEFORE OPERATION
SAFETY
Before operation, check if the voltage of
the unit is in tine with the local voltage.
Hold the plug to disconnect it from the
mains outlet. Do not pull the power cord.
When the plug of the unit is connected to
the mains outlet , the unit will be still
connected to AC even if the power is
turned off.
Disconnect the plug as soon as liquid or
objects enter the unit. The unit can not be
used until being checked by experts.
Do not open the cabinet for laser rays
employed by the unit may damage eyes.
Any servicing should be done by qualified
service personnel.
PLACEMENT
Product intended for table top or top
surface operation only.
Never put the unit in direct sunlight or near
heat sources.
Put the unit horizontally, never put any
heavy object on the unit.
To protect the laser, do not put the unit
where there is most dust. If there is dust
on the laser, use a cleaning disc to clean it.
Refer to the operation instructions of
the cleaning disc you bought.
CONDENSATION
Water will appear on the pickup lens in
the following cases:
The unit is suddenly moved a cold place to
a warm place.
The unit is put In a room with a heater, or
In the cold air from a air-conditioner.
Use the unit in a humid place. In these
cases, the unit can not work. Unload the
disc and leave the unit on for about
one hour to evaporate the water.
CLEANING
Use soft cloth with a little neutral
detergent to wipe the cabinet, panel and
controls. Never use abrasive paper,
polishing powder or solvent like alcohol
and gasoline.
H. PRECAUTIONS FOR DISC
HANDLING DISC
To keep the disc clean, do not touch
the play sides of the disc.
^ Do not attach paper or tape to the disc.
Keep the disc away from direct sunlight
or heat sources.
Store the disc in a disc case after
playback.
CLEANING DISC
Before playback, wipe the disc outwards
from the center with clean cloth.
Do not use any type of solvent such as
thinner, benzine, commercially available
cleaners or antistatic spray.
^§6®§