Remote starter features, Keyless entry features, System features – Bulldog Security 22I User Manual

Page 4: Operating instructions

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SYSTEM FEATURES

Remote Starter Features

Remote

Programmable

Low Voltage Start

Remote

Programmable

Run Time

Remote

Programmable

Extended Crank Time

Dedicated Start and Stop

Buttons

Diesel Start Capability

Remote Programmable

Ignition Controlled

Door Locks*

Trunk Release*

Dome Light Supervision*

Parking Light

Confirmation

Multi-Remote Learning

Remotely program your vehicle to automatically start when №e
battery voltage drops below 11 volts.

Remotely program your vehicle to run from 5 to 25 minutes.

Remotely program a longer engine cranking for hard starting

vehicles.

Uses separate buttons to start and stop the remote starter.

Allows you to program №e unit to remote start a diesel vehicle.

Keyless Entry Features

Remote Keyless Entry*

Remotely locks and unlocks your power door locks with built-in
relays onboard.

A programmable feature №at locks and unlocks the doors when the

brake is depressed and the ignition is on.

Remotely opens your trunk with a push of a button.

Never walk up to a dark vehicle again. When unlocking the vehicle
by remote control the dome light will stay on for one minute, or
until you activate the ignition switch.

Confirms that your vehicle has received a remote signal and will

remain on if the engine is remotely started.

Allows your remote starter to learn new remotes, should you want
to add remotes, or if remotes are lost.

Limited Lifetime Warranty Guarantees life-long protection.

*

Optional feature.

*2003 А«ем 2 Comfflunkati<m$, Inc.

OPERATING INSTRUCTIONS

Button #1: Remote starts your vehicle from up to a quarter

mile.

Button #2: Arm locks and disarm unlocks your power door

locks.

Button #3: Pops your trunk.

Button #4: Turns off your remote starter and helps you

locate your car (when system is armed).

Starting the Vehicle with the Remote Transmitter

Press and release Button #1 (Start). The parking lights will flash once, confirming the car

starter received the signal. The car will then start and the parking lights will turn on and
remain on while the vehicle is running. To shut off the enoine before the preset time, press

Button #4 (Stop), press the brake pedal or open the hooa. NOTE: If your car does not start

on the first crank it will automatically attempt to start up to 3 more times (only in Tachless

Mode). In Tachless Mode, parking lights will wait approximately 10 seconds before turning

on after the vehicle is remotely started.

Keyless Entry
Press Button (Lock/Unlock), the parking lights will flash once and the doors will lock. Press

Button #2 again, the parking lights will flash twice, the doors will unlock, and the parking
lights will remain on for one minute or until you turn the ignition on and press the brake.

Pit Stop: Exiting the Car while Leaving the Engine Running
Make sure the transmission is in park and press Button #1 (Start) before turning the ignition

switch off. (The engine will remain running for the preset runtime.)

Dome Light Supervision Option

This system includes an optional output that can be used to illuminate the dome light when

pressing Button #2 and unlocking your doors*. The dome light will remain on for one minute

or until you turn the ignition on and press the brake.

21

*2003 Acce» 2 Communketions. Inc

Advertising