Bulldog Security 22I - Manual (Page 7)

PROGRAMMING INSTRUCTIONS NEUTRAL SAFETY SWITCH
WE RECOMMEND THAT YOU USE FACTORY SETTINGS FIRST
Entering Programming Mode
Make sure your key is not in the ignition and the brake i$ pressed. The brake is to remain
pressed as long as you want to remain in programming mode. The unit will exit the prog^ramming
mode simply by releasing the brake. The parking lights will flash three (3) times conrtrming
that you are out of programming mode.
Programming Double Crank Time
Press and hold i the brake, then press and hold Button #3 (Tnjnk) until the parking lights flash
three (3) times. Release Button #3. Press and release Button #3, the parking lights will Rash
once. The Double Crank is on. Press and release Button #3, the parking lights will flash twice,
Double Crank is now off. Release the brake, the parking lights will flash three (3) times, the
programming is now entered. NOTE: Factory setting is Double Crank off.
Adding New Transmitters
Press and hold the brake, then press and hold Button #1 (Start) on the working remote until
the parking lights flash once. Release Button #1. Press any button on the new remote, the
parking lights will flash three (3) times, the new remote is now programmed.
Programming Lock with Brake, Unlock with Ignition Off
Press and hold the brake, then press and hold Button #3 (Trunk) until the parking lights flash
three (3) times. Release Button #3. Press and release Button #2, the parking lights will flash
once. The unit will now lock with №e brake and unlock when the ignition is turned off. Press
and release Button #2 again, the parking lights will flash twice. The Lock wi№ Brake feature
is now turned off. Release the brake, №e parfong lights will flash three (3) times. The programming
is now entered. NOTE: Factory setting Is Lock wtth Brake off.
Programming Door Lock Pulse Length
Press and hold the brake, then press and hold Button #3 (trunk) until the parking lights flash
three (3) times. Release Button #3. Press and release Button #1, the parking lignts will flash
once, the door lock pulse length is now 3.5 seconds. Press and release Button #1, the parking
lights will flash twice, the door lock pulse length is now .7 seconds. Release the brake, the
parking tights will flash three (3) times. 13ie programming is now entered. NOTE: Factory Door
Lock Pulse Setting is .7 seconds.
Programming Double Pulse Unlock
Press and hold the brake, then press and hold Button #4 (stop) until the parking lights flash
four (4) times. Release Button #4. Press and release Button #3, the parking lights will flash
once. Double Pulse Unlock is on. Press and release Button #3 a second time, the parking lights
will flash twice. Double Pulse Unlock is off and Double Pulse Lock is on. Press and release
Button 03 a third time, the parking lights will flash three times. Double Pulse Lock and Double
Pulse Unlock are on. Press and release Button 03 a fourth time, the parking lights wilt flash
four times. Double Pulse Lock and Double Pulse Unlock are now programmed
off. NOTE: Factory
Setting is Double Pulse Unlock off.
18
C2O03 Accnt} Comnun<Mtonv Inc
MECHANICAL NEUTRAL SAFETY SWITCH (Rear Wheel Drive Only)
When installing a Bulldog Security remote starter on GM vehicles or Dodge
Dakotas built prior to 1996, you must: Use the diagram below to create
a circuit that will prevent the remote starter from starting the vehicle
unless the key is removed from the ignition switch.
PRE-1996 GM REAR WHEEL DRIVES
WITH PURPLE CRANK WIRE - Optional relay required.
Driver's Door Switch
Key
Cylinder
PRE-1996 DODGE DAKOTAS - Optional relay required.
C200J AcmtZCommwnkMtonvinc