Bolens 248-645A - Manual (Page 5)

ASSEMBLY INSTRUCTtONS
1. Pack the tapered roller bearings with automotive
' grease.
NOTE
Do Not put any grease in the hub caps.
2. Place one spacer (C) on axle, next one wheel, and
tapered roller bearing (A). See figure 3.
■' ' ■ ' . 4
WHEEL TAPERED
ROLLER
BEARING (A)
FIGURES
Thread hex castle nut (D) on axle. Tighten castle
nut until snug, back off approsimately 1/3 turn
or until one of the slots on the castle nut lines up
with hole in axle. Secure castle nut to axle with
cotter pin (E). See figure 4.
FIGURE 4
4. Place hub cap (B) in position on wheel and tap on
with a plastic hammer. See figure 5.
FIGURES