Bernina 740E User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
Inserting the needle
(SyiteiTi 13O705H)
I Change the needle regularly.
I especially if it is showing signs of
wear ar>d causing problems.
Insert the needle as illustrated as
follows:
A Loosen the needle damp screw
arxf lighten again after inserting
the new needle. (1)
B The flat side of Ihe shaft should
be towards the back.
C/D Insert Ihe needle as far up as it
will go.
Attontion:
Turn power switch to “O’!
Needles must be in p»^eci condition.
(
2
)
Problems can occur with:
A bent needles
B blunt needles
C damaged points
26
Advertising
This manual is related to the following products: