Lighting the side burner, Match lighting the side burner, Turning off the grill – Brinkmann GRAND GOURMET 6345 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

LIGHTING THE SIDE BURNER:

1. Open lid before lighting side burner.

2. Make sure control knob is in the "OFF" position.

3. Push and turn side burner control knob to the "FIIGFI" position.

4. Press the electronic igniter on the main control panel and

hold for 3-5 seconds to light burner.

5. It ignition does NOT occur in 5 seconds, turn control knob to

"OFF", wait 5 minutes to allow gas to dissipate and repeat
lighting procedure.

6. To turn oft, turn each control knob clockwise until it locks in the

"OFF" position.

NOTE: It burner does not light or flame is too low, you may have spider or other insect blockage in burner,

or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper
Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and
Flose/Regulator to Grill.

MATCH LIGHTING THE SIDE BURNER:

1. Open the lid to the side burner before lighting.

2. Turn the burner control knob to "OFF”.

3. Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.

4. Turn the side burner control knob to the "FIIGFI" position. The burner should light within 5 seconds.

5. It the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and

repeat lighting procedure.

6. If the burner does not light within the first few attempts of match lighting, there is a problem with the

gas supply. Turn oft the gas at the burner and cylinder. DO NOT attempt to operate the grill until the
problem is found and corrected. See "Trouble Shooting" section of this manual.

NOTE:

Observe flame height when lit: Flame
should be a Blue/Yellow color between

1"-2" when burner is on "HIGH”.

TURNING OFF THE GRILL:

1. Turn oft the cylinder valve.

2. Turn all burner control knobs to the "OFF" position.

NOTE: Turn oft LP cylinder first to prevent gas from being left in the system under pressure.

Advertising