Bolens 190-746-000 - Manual (Page 3)

Rules for Safe Operation (continued)
25. Keep the vehicle and attachments in good operating con­
dition, and keep safety devices in place. Use guards as
instructed in operator's manual.
26. Keep all nuts, bolts, and screws tight to be sure the equip­
ment is in safe working condition.
27. Never store the machine with fuel in the fuel tank inside
a building where ignition sources are present, such as
hot water and space heaters, clothes dryers, and the like.
Allow the engine to cool before storing in any enclosure.
28. To reduce fire hazard, keep engine free of grass, leaves
or excessive grease.
29. The vehicle and attachments should be stopped and in­
spected for damage after striking a foreign object. The
damage should be repaired before restarting and
operating the equipment.
30. Do not change the engine governor settings or overspeed
the engine.
31. When using the vehicle with tiller, proceed as follows:
(1) Till only in daylight or in good artificial light.
(2) Never make any adjustments while engine is
running if operator must dismount to do so.
(3) Use caution when tilling near buildings and fences.
Rotating tines can cause damage or injury.
(4) Check the tine mounting bolts at frequent intervals
for proper tightness.
32. Look behind to make sure the area is clear before placing
the transmission in reverse and continue looking behind
while backing up. Disengage tiller before shifting into
reverse and backing up.
33. This unit should not be driven up a ramp onto a trailer
or truck under power, because the unit could tip over,
causing serious personal injury. The unit must be push­
ed manually to load properly.
ASSEMBLY INSTRUCTIONS
NOTE
Right and left hand side of the unit is
determined from the driver's seat,
facing forward.
-Contents of Hardware Pack {See figure 1):
A (1)
B (1)
C (1)
D (2)
FIGURE 1
E
F
G
H
I
J
K
M^(l)
N (2)
O (3)
P (1)
Q (1)
(4)
(4)
(4)
(
1
)
(
1
)
(5)
(4)
Extension Spring
Flat Washer 1/2" I.D. x 1-1/2" O.D.
Flat Washer 5/8" I.D. x 1-1/4" O.D.
Flat Washers 1/2" I.D. x 1" O.D.
Hex Bolts 3/8-24 x 7/8" Long
Lock Washers 3/8" I.D.
Hex Nuts 3/8-24 Thread
Hex Bolt 5/16-24 x 1" Long
Spiral Pin
Hairpin Cotters
Extension Springs (Not Shown)
Hex Bolt 5/16-24 x 1-1/2" Long
Lock Washers 5/16" I.D.
Hex Nuts 5/16-24 Thread
Ferrule
Spacer 1/2" I.D. x 1" O.D. x 1/2" Long
• Loose Parts in Carton (See figure 2):
R (1) Carriage,Bracket Assembly
S (1) Idler Bracket Support Arm Assembly
T (2) Support Pivot Brackets
U (1) Compression Spring
V (1) Idler Bracket Assembly
W (1) Lift Rod Assembly
FIGURE 2