Bolens 190-746-000 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
DRIVE PULLEY
27.
FIGURE 14
Assemble the belt as follows (refer to figure 14).
A. Belt is attached to the idler pulley assembly.
Back of the belt (flat side) goes against the
idler pulley.
B. Slip belt up and over pulley on tiller ("V" side
of belt goes against the pulley).
C. Twist the belt 90° to the right as shown in
figure 14. Slip the belt around the drive pulley
on the tractor.
NOTE
The tines on the tiller are designed to
rotate in the opposite of the wheels
on the tractor. If they rotate in same
direction as the wheels, the belt is
twisted
in
the
wrong
direction.
Unhook the belt from the drive pulley
and twist in the opposite direction.
If there are holes provided in the tractor frame,
hook the lift links up out of the way using the
four extension springs (K). See figure 15.
FIGURE 15
8