Bolens 190-746-000 User Manual
Page 5
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
10
.
11
.
Secure end of idler bracket support arm
assembly on the right side of tractor with one
flat washer (D) and hairpin cotter (J).
Place carriage bracket assembly (R) in position
beneath the running board support rod on the
tractor. Secure each side of carriage bracket to
frame with hex bolts (E), lock washers (F) and
hex nuts (G). Tighten securely. See figure 6.
ROUND
BELT Til
GUARD
II
HAIRPIN COTTER'
WIRE
BELT
GUARD
IDLER PULLEY
Remove the round belt guard from the idler on
tractor by removing the hairpin cotter. See figure
7A or 7B.
FIGURE 7A
HEX BOLTS
13. Remove the engine pulley belt guard by either
unscrewing
the
belt
guard
release
and
swinging the engine pulley belt guard out of the
way (see figure 7A), or removing the two long
hex bolts which act as belt keepers (see figure
7B).
14.
Place the belt which is preassembled to the
carriage bracket assembly around the idlen
pulley and engine pulley on the tractor.
15.
Reassemble the round belt guard and hairpin
cotter. Reassemble the engine pulley belt
guard(s).