Aiwa CX-NA303 - Manual (Page 17)

SEHING THE TIMER
I
2.4
1.2.3.4
The unit can be turned on at a specified time every day with the
buiit-in timer.
Preparation
Make sure the ciock is set correctiy.
Use the remote controi.
1 Press TIMER to display ©, then press I I SET
within 6 seconds.
® is dispiayed and the hour fiashes.
?
e
: ;
If you press
II SET after 6 seconds, another operation may
start.
2 Designate the hour of the timer-on time by
pressing ◄◄ DOWN or ►► UP, then press I I
SET.
Repeat to designate the minute of the timer-on
time.
4 Select the duration for the timer-activated period
with « DOWN or »■ UP, then press II set.
\ i /
XyW '--.v .
0^ /1 \ ' kc-
The duration for the timer-activated period can be set between
5 and 240 minutes in 5-minute steps.
5 Prepare the source.
To listen to a CD. ioad the disc to be played first on tray 1 .
To listen to a tape, insert the tape into deck 1 or 2.
To listen to the radio, tune in to a station.
6 Press POWER to turn the unit off after adjusting
the volume and tone.
® remains on the display after the power is turned off (timer
standby mode).
F f 1 № W
When the timer-on time is reached, the unit turns on and
begins play with the selected source.
The volume level is automaticaliy set to 16 when the power is
turned off with the velume ievei set to 17 or more.
To check the specified time and source
Press TIMER. The timer-on time, the seiected source name and
the duration for the timer-activated period are displayed for 4
seconds.
To cancel timer standby mode temporarily
Press TIMER repeatedly until ® disappears on the display.
To restore the timer standby mode, press TIMER once or twice
to dispiay ®.
Using the unit while the timer is set
You can use the unit normaiiy after setting the timer.
Before turning off the power, carry out step 5 to prepare the
source, and adjust the volume and tone.
' Timer playback and timer recording will not begin unless the
power is turned off.
' Connected equipment cannot be turned on and off by the buiit-
in timer of this unit. Use an externai timer.
CC
u
s
H
D
Z
<
Z
o
o
'
MULTI JOG is also available instead of
- '
and I
After you designate the timer-on time, one of the source names
fiashes on the dispiay.
3 Press FUNCTION to select a source, then press
I I SET.
• If TUNER is pressed, the band cannot be selected in this
step.
TIMER RECORDING
Timer recording is appiicabie for TUNER and VIDEO/AUX (with
an external timer) sources only.
Press TIMER repeatedly until ® flashes on the display, then
press
II SET within 6 seconds. Carry out the steps of
“SETTING THE TIMER” from step 2 and insert the tape to be
recorded on into deck 2 after step 5.
ENGLISH
1 6