Aiwa XR-M75 - Manual (Page 15)

CLOCK AND TIMER
I
SEHING TH
OOQ
QQO
<£ c £ o
C5«>0
c :>o
■jklQ
3 -
ooo
ooo
o
1
2
o
z
5
a
o
o
U1
a
GC
Ul
S
P
Q
Z
<
z
o
o
i Press CLOCK/DIMMER once, then press ENTER
within 4 seconds.
5 > > : / K ! 1 1 2 s 0 0
When using the remote control
Press; CLOCK while pressing SHIFT, then press IISET within
4 seconds.
2 Turn MULTI JOG to designate the hour, then press
ENTER.
The hour stops flashing and the minute starts flashing.
3 Turn MULTI JOG to designate the minute, then
press ENTER.
The minute stops flashing on the display and the clock starts
from
00 seconds.
To display the current time
Press CLOCK/DIMMER once. The time is displayed for 4
seconds;.
However, the time cannot be displayed during recording.
To switch to the 24-hour standard
Press CLOCK/DIMMER once and then press ■ within 4
seconds.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours,
all settings stored in memory after purchase need to be reset.
-« and ► ► are also available instead of MULTI JOG.
IISET is also available instead of ENTER.
The unit can be turned off automatically at a specified time.
Use the remote control.
1 Press SLEEP while pressing SHIFT.
iSg^USLEEP
60
2 Within 4 seconds, turn MULTI JOG or press
or to specify the time until the power is turned
off.
The time changes between 5 and 240 minutes in 5-minute
steps.
Specified time
.[SLEEP
To check the time remaining until the power is turned off
Press SLEEP once while pressing SHIFT. The remaining time
is displayed for 4 seconds.
To cancel the sleep timer
Press SLEEP twice while pressing SHIFT so that “SLEEPoFF”
appears on the display.
ENGLISH 14