Avanti HUM2000 - Manual (Page 9)

Accumulated dirt in the dust compartment will collect on this filter and may restrict motor performance
When the filter becomes dirty, pull it from the bottom of the dust compartment and clean when
finished slide the filter back into place. It should be fuliy inserted under the plastic rib projections all
the way to the rear compartment wall. Put cassette with filter back in vacuum.
Model HMU1100
The electrostatic exhaust filter is located in a cassette inside the dust compartment body The
purpose of this filter is to remove dust and dirt from the re-circulated air. It is capable of filtering
very fine dirt particles This filter cannot be cleaned and should be replaced at least once per year
if the cleaner is used at least one hour per week.
Model HMU2000
The hepatype exhaust filter is located in a cassette inside the dust compartment body The
purpose of this filter is to remove dust and dirt from the re-circulated air. It is capable of filtering
very fine dirt particles. This filter cannot be cleaned and should be replaced at least once per year
if the cleaner is used at least one hour per week,
! ! 1
> TO ADJUST CARPET HEIGHT
Your Home Maker Upright Vacuum cleaner is designed with a low to high adjusting rug nozzle. The
height of the rug nozzle can be lowered or raised to any carpet pile height. This adjusting feature
allows the rug nozzle to float evenly over ail carpet pile surfaces.
> REPLACING THE BELT
Before replacing any parts, disconnect the vacuum cleaner from the electrical outlet.
To replace the drive belt, place the handle in the low position. Then turn the vacuum cleaner over,
exposing the underside. Release the lower plate by sliding the two plate lock buttons that hold the
lower plate on. Then remove the lower plate.
Turn the unit over, remove the lower plate as described in the preceding section. Remove the top left
packing and take out the agitator assembly (just lift out), and remove the worn or broken belt from the
agitator pulley and motor drive shaft. Loop the new belt around the motor drive shaft and then loop it
around the agitator pulley. Use only a Home Maker type BU3 drive belt.
Reinstall the agitator assembly back into the housing grooves. After installing agitator turn it by hand
making sure the belt is not twisted and all rotating parts turn freely. Replace the felt packing. Use
replacement genuine belts BUS.
---—- 'i
To Reinstall Lower Plate
Hook the front end of lower plate under the three ribs at the front end of the housing. Then, press the