Alvin MiniMaster II Drawing Table - Manual

MiniMaster II
Drawing Table
Assembly Instructions
April 2008
Tools required: Phillips screwdriver.
Parts Included:
A 2pcs Leg Frame B 1pc Table Top
E 1pc Back Panel
Colored surface both sides
G 2pcs
Rear Extension Tubes
n 4 F Shelf H 2pcs
C 4pcs Casters
y
^pcs Colored surface one side only Front Extension Tubes
Floor Glides
Right
Rear Front
I 4pcs
Height Adjustment Knobs
J 2pcs
Side Cross Bars
K 6pcs
1-1/2" Allen Bolts
L Ipc
Front Cross Bar
M 2pcs
Tilt Mechanisms
Left
N 2pcs
Nyion Washers
0
6pcs
1-1/4" Alien Boits
P 12pcs
1/2" Ailen Bolts
Q 2pcs
Table Top Brackets
Right
R lOpcs
5/8" Wood Screws
S Ipc
Pencil Ledge
T Ipc
Allen Key
U 2pcs
Spacer
V 1pc
Reinforcing Bar
To Assemble:
Unpack and inspect contents to confirm that you have all parts listed above
Screw casters (C) or floor glides (D), whichever you prefer, into
■ gnt....................... “ bottom tubes of left and right leg frames (A)
n Place back panel (E) on a bench or table (at least 20” high) with
“ ends hanging over the edge and threaded holes facing up.
Note Back panel has colored PVC coating on both sides.
Dont confuse it with the shelf that has coating only on one side.
□
Hang left leg frame (A) on top of back panel (E) as shown in diagram.
Align holes in steel flange with holes in back panel and install
1/2'^’ Allen Bolts (P). Be sure ends of back panel are pushed flush
against steel tubing and tighten bolts securely.
Repeat step #4 for right leg frame (A)