Alvin MiniMaster II Drawing Table User Manual
Page 3
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Place tabletop (B) on carpeted or protected floor with pre-drilled side facing up. Attach Reinforcing
Bar (V) to tabieiop using 1-1/4" Aifen Bolts (0) into threaded hoies in tabietop. Tighten secureiy.
Carefuily turn base assembiy upside down and piace on tabietop. Aiign hoies in Tiit Mechanisms
(M) with threaded holes in tabietop. Connect using 1/2" Aiien Boits (P) and tighten firmiy.
Align Tabie Top Brackets (Q) with the 2 sets of pre-driiied holes. These brackets should straddle
and capture the Front Cross Bar (L). Attach brackets using 5/8” Wood Screws (R). Be carefui not
to over tighten or you might strip the hoies
Carefuily return table assembly to the upright position.