Alvin MiniMaster II Drawing Table - Manual (Page 2)

Carefully remove base assembly from table/bench
and place upright on floor. Use care not to overstress
back panel connections at this time.
Place shelf (F) with pre-drilled holes facing down onto the steel shelf flanges.
Attach with
V2”
Allen bolts (P) from below. Be sure ends of shelf panel are
pushed flush against steel tubing and tighten bolts securely.
Extension tube holes
align with height
adjustment knobs when
half of the hole above
is showing.
Insert front and rear extension tubes (G and H) into base assembiy.
Pay close attention to correct orientation and position of ieft and
3yi
right tubes,as shown in diagram. Install height adjustment knobs
(I) in each leg and set each extension tube in the third hole for the
time being.
Extension tube holes align with height adjustment knobs when
haif of the hole above is showing.
Attach Side Cross Bars (J) between extension tubes using 1-1/2"
Allen Bolts (K) as shown in diagram.
Attach Front Cross Bar (L) to front extension
tubes using 1-1/2 Alien Bqits (K) and plastic
îing
spacers (U) as shown in diagram.
Attach Tiit Mechanisms]M) to Side Cross
Bars using 1-1/4" Allen Bolts (
Washers (N) as shown in diagram
Double check that the left tilt mechanism is
attached to the tilt mechanism will face Inward,
left side and the right tiit mechanism is attached
to the right side.If correctly attached,
the elongated "tabs" on the end of each
Set base assembly aside.
0