American Standard Moments T506.60X User Manual
Page 2
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSTALL DIVERTER
When finished tiling the wall, remove PLASTER GUARD (1).
Remove two screws that secure the DIVERTER LID [2) and
remove Lid. Inspect the inside surface of diverter port.
Diverter port must be free of any dirt. Clean if necessary.
Install DIVERTER
(3)
with SCREWS
(4)
removed with
DIVERTER LID
(2).
Operate DIVERTER
(3).
DIVERTER
(3)
should slide in
and out smoothly.
DIVERTER
PORT
INSTALL VALVE TRIM
Figure 1.
Push CAP
(1J
over VALVE CARTRIDGE
(2)
until
seated against stop. Push CAP
(3)
over DIVERTER
(4)
until
seated against stop.
Figure
2. Push ESCUTCHEON HOLDER
(5)
onto CAP(1J
and attach with SCREWS
[S).
Mount ESCUTCHEON
SUPPORT
(7)
to ESCUTCHEON HOLDER
(5)
with
SCREWS (8).
Figure 3.
Align PINS (10) on back side of ESCUTCHEON (11)
with the FOUR HOLES
(12)
in ESCUTCHEON SUPPORT
(7)
and press ESCUTCHEON
(11)
flush against finished wall.
Figure 2.
M968952