American Standard Moments T506.60X User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
HANDLE INSTALLATION,
INSTALL HANDLE ADAPTER
Push HANDLE ADAPTER
(1J
onto VALVE STEM
(2).
Tighten set screw
(3)
with 2.5mm hex wrench
supplied.
5a
INSTALL ADAPTER SCREW
With a flat blade screwdriver thread ADAPTER SCREW
(4)
into
HANDLE STEM ADAPTER
(2)
and tighten.
2.5MM
HEX
WRENCH
5c
INSTALL HANDLE
5b
INSTALL ADPATER
With a flat blade screwdriver thread ADAPTER
(5)
onto SET SCREW
(4)
and tighten.
Align HANDLE [6) and install onto HANDLE ADAPTER
ASSEMBLY
(7J.
Tighten set screw
(8)
with 2.5mm hex wrench
supplied to secure HANDLE.
Push PLUG BUTTDN (S) into set screw access hole in
HANDLE (6).
Z.SMM HEX
WRENCH
SERVICE
If faucet drips, operate handle several times
from "off" to "on". Do not apply excessive force.
Clogged CARTRIDGE
(4)
inlets may cause reduced
flow in "full on" hot or cold. To clean inlets, first turn
off water supply, then:
■ Remove HANDLE
(1J,
CAP
(2)
and CARTRIDGE
(4).
■ Clean inlets and MANIFDLD
(5).
■
Reassemble CARTRIDGE
(4J,
alternately tightening
SCREWS
(3).
Replace CAP
(2)
and HANDLE
(1).
Check flow.
EverClean™ Finish Care Instructions
American Standard’s EverClean finish will wipe clean with a soft, dry cloth. A soft cloth with
clean water may also be used, if desired. IMo additional cleaning products are required.
DO NOT USE: Soaps, acid, polish, abrasives, harsh cleaners, or a cloth with a coarse surface.
M968952