Aiwa XR-H330MD - Manual (Page 25)

4
3
When the CD playback ends
Recording to MD and tape ends automatically.
At the end of recording of the MD or tape
When the MD is recorded to the end, but the tape is still
recordable, the recording continues.
When the tape is recorded to the end, but the MD is still
recordable, the recording continues.
When both the MD and tape are recorded to the end and if CD
playback still continues, stop it with ■.
To stop recording, press ■.
Press ■ again to stop CD playback.
When more than two CDs are loaded, start playback of the
desired CD by pressing DISC DIRECT PLAY (1 - 3), and stop
playback. Then, start the operation from step 2.
(3
z
5
a
o
u
Id
oe
a
• To 'ecord on a previously recorded MD, the new recording
automatically starts from where the previous recording finished.
• Set the tape to the point where recording will start.
• Y
ol can select the reverse mode (recording on one side or
recording on both sides).
If you select the recording on both sides, during the time of
changing tape side, the CD playback continues.
1 Insert a CD on tray 1.
Up to three CDs are inserted,
rescorded. but only one CD can be
2 Insert an MD to be recorded on with the label side
up and in the direction of the arrow.
3 Insert a tape to be recorded on into the deck 2.
4 Set the tape to the point where recording will start
with ■« or and stop the tape with ■.
5 Select the reverse mode using MODE, ENTER and
MULTI JOG (page 10).
Tc record on one side only, select "Z".
Tc record on both sides, select "ZT or "CD".
• When recording from the rear of the tape, the tape stops at
the end of recording of the rear side, even if the reverse
mode is set to "ZT or "CZy.
6 Press CD ► MD/TAPE.
When the CD playback begins, recording to MD and tape starts
simultaneously.
• If a tape is not loaded on the deck 2 or an MD is not loaded,
CD MD/TAPE does not function.
ENGLISH
25