AEG 222D - Manual (Page 16)

Warning
• Failure to observe the instructions on cleaning the unit and
changing the filters will cause a fire hazard. You are therefore
strongly recommended to follow these instructions.
Changing the light bulb
• Disconnect the unit from the mains power supply.
• Remove the grid.
• Replace the old light bulb with a new light bulb (40 W
max.).
• If the light does not come on, make sure the bulb has
been screwed in correctly before contacting the technical
assistance service.
Cleaning
• Warning: always disconnect the hood from the mains power
supply before cleaning it.
Never insert pointed objects in the motor's protective grid.
• Wash the outside surfaces using a delicate detergent solution.
Never use caustic detergents or abrasive brushes or powders.
• Only ever clean the switch panel and filter grille using a damp
cloth and delicate detergents.
•It is extremely important to clean the unit and change the filters
at the recommended intervals. Failure to do so will cause grease
deposits to build up that could constitute a fire hazard.
Accessories
The following accessoires can be ordered through your retailers.
MKZ telescopic wall pipe outlet hose ABS120 ,120 mm 0
Synthetic grease filter
Metal grease filter MFF2
Carbon filter KFF
1 6