Audiovox MVX-550 - Manual (Page 15)

To Place a Call with a Number in the
Memory
1. Press then enter the memory address (01
through 99), The last 10 digits of the number will
appear on the readout. If the number is longer than
10 digits, hold down the second digit of the memory
address (after pressing llOi ) to see the prefix.
Note: See “To Recall a Number from Memory” and
“To Review the Prefix” for more details.
indicator will light as the 2.Press SBKEi. The I
call is placed.
Speed Dialing
This feature permits you to place a call from the stored
memory locations without using the recall key.
Speed dialing is a quick method of placing calls from
memory.
1. Enter the one or two digits of memory address (1
through 9 and 10 through 99).
2. Press The last 10 digits of the phone number
will appear on the readout, and the indicator
will light.
Last Three Number Redial
This feature permits you to redial any of the last three
phone numbers you attempted to call.
Numbers will be stored in memory only if key
is pressed.
Note: If same telephone number is attempted more than
once phone will only utilize one memory location.
1. Press key S then S]. The last phone number
is displayed on the readout.
2. Press Iffl or S, the scrolled number is displayed on
the readout.
[S : Scroll upward (with roll back to #1)
[Si
: Scroll downward (with roll up to #3)
Press iSBNiSj to send a displayed number. 3.
Note: To
Programmable Emergency Call
(NAM Option)
This feature permits you to place a call to 3 emergency
numbers (maximum of 7 digits) even if your telephone
has been set to the locked or restricted modes.
The three emergency numbers must be pre-programmed
in the NAM,
Note: 911 is preset emergency number, (you may change
this number if you wish.)
Operation in Lock Mode _
1. Enter the emergency call number (911);
31 S
(“911” does not indicate, but the tSKSKi indicator will
light.)
2. Press the ^£1^ indicator will light.
3. To terminate the call, press ISitOl. (The indi­
cator will go out.)
Operation in Call Restriction Mode
The operation and display are the same as in the normal
mode.
To Mute a Phone Conversation
2 .
3.
Press MSG, then key will appear on the
readout. The transmit audio will be muted and the
receive audio will be heard from the receiver. The
mute (or hold) feature will permit you to converse
privately with a passenger during a call.
To return to normal conversation:
Press then key IMi again.
Mute is reset when the call is terminated.
clear the stored
three times.
number, press iGkH. then
27 28