Aiwa AV-D55 - Manual (Page 18)

SEHING THE CLOCK SETTING THE SLEEP TIMER
■CLOCK
When the AC cord is connected for the first time, the clock on
the display flashes.
Set the time as follows while the power is off.
1 Press the ENTER button.
The display becomes a little brighter.
2 Turn the MULTI JOG to designate the hour and
the minute.
The time advances by turning it to right, and decreases by
turning it to left.
The DOWN or UP button is also available. Press the button
repeatedly. To change the time rapidly in 10-minute steps,
hold it down.
3 Press the ENTER button.
The clock starts from 00 seconds.
When the clock is set for the first time after purchase
Everything on the display will clear.
This is because the power economizing mode of the unit is
activated, and is not a malfunction.
The power economizing mode can be canceled. See page 6 for
details.
To correct the current time
Press the POWER button to turn the unit off. Press the ENTER
button and carry out steps 1 to 5 above.
To display the current time
Press the CLOCK button on the remote control. The clock is
displayed for 4 seconds.
To switch to the 24-hour standard
Press the VIDEO 1/5.1CH/BAND button while the current time
is displayed.
Repeat the same procedure to restore the 12-hour standard.
If the clock display flashes while the power is off
This is caused by a power interruption. The current time needs
to be reset.
If power is interrupted for more than approximately 24 hours, all
settings stored in memory after purchase need to be reset.
The receiver can be automatically turned off at a specified time.
Use the remote controi.
1 Press the SLEEP button.
I CAVll r-ivT; -¡TO- Ti-TiAl
\ ROCKirpBPlI JAZZII CLftSSidrBGi
2 Press the UP or DOWN button within four
seconds to specify the time untii the power is
turned off.
Each time the button is pressed, the time changes between 5
and 240 minutes in 5-minute steps.
t Mdckt fpo^ i JAZizl f CLAS'^d i ~ bgm 1
Specified time
The time can also be selected by the MULTI JOG on the main
unit.
To check the time remaining until the power is turned off
Press the SLEEP button once. The remaining time is dispiayed
for four seconds.
To cancel the sleep timer
Press the SLEEP button twice so that “SLEEPoFF” on the display
appears.
17 ENGLISH