Adcom GCD-700 - Manual (Page 8)

DISC SKIP Oi
This button is used to skip over to the next disc. It works with the drawer in the open or closed position and must be used when
loading a disc in the rear-most position of the disc tray, this button will not operate when the drawer is open and a disc is
playing or if a disc was playing when the drawer was opened.
CAUTION
tXD NOT ATTEMPT TO MANUALLY ROTATE THE DISC TRAY AS DAMAGE MAY RESULT.
POLARITY ai
This control is used to reverse the normal, positive-going output signal of the GCD-700 to a negative or inverted output signal.
The LED in the center of the button will glow whenever the negative, inverted signal is selected. Whenever the GCD-700 is
turned on, the positive polarity will automatically be selected, even if the reverse polarity had been selected when the player was
turned off. this feature has the potential to improve the sound quality on certain discs depending on how they were originally
recorded. Experimentation on your different discs will reveal which, if any show this positive effect.
PLAY®
Press this button to start playing a disc. If you select the track you want to listen to by using one of the TRACK SELECTION
buttons, operation of this button is not necessary as the player will automatically go into the play mode and the LED in the
center of this button will glow.
PAUSE
m
This button is used to temporarily stop the GCD-700 from playing a disc. To resume play of the disc at the precise point at
which the PAUSE mode was engaged, press the PAUSE button again or press the PLAY button.
STOP®
Press this button to stop play.
OPEN/CLOSE
®
This control is used to open or dose the drawer.
CAUTION
DO NOT ATTEMPT TO CLOSE THE DRAWER MANUALLY BY PUSHING IT IN AS DAMAGE MAY RESULT.
FORWARD SEARCH (D
Press this button once to skip to the next track on the disc, repeat this procedure to continue skipping tracks. Press and hold
this button to fast fonvard within a track to locate a desired portion of a song.
REVERSE SEARCH
®
This button performs the same function as the FORWARD SEARCH control except it works in the reverse direction,
example, pressing this button once will bring the player back to the beginning of the track being played.
For
PROGRAMMING THE GCD-700
By following the steps below, you can program the tracks that you want to listen to in the order that you select. The maximum
number of tracks that can be programmed is twenty. Programmed tracks can be chosen from one or more discs.
To program the GCD-700, proceed as follows:
• If you have not already done so, load the discs in the disc tray.
• Press the PROGRAM button, the LED in the button.will glow indicating that you are in the program mode and the GCD-700
is ready to accept program selections. If the unit is already playing a track or in the pause mode, the unit will automatically
program that track as the first selection.
6