Adcom GCD-700 - Manual (Page 9)

• Select the disc you want to want to program and listen to by using DISC 1 though DISC 5 buttons.
• Press the TRACK SELECTION button that corresponds to the track that you want to program and listen to.
• Repeat steps 3 and 4 above as required until you have programmed all the desired tracks.
• Press PLAY to start listening to the selections you have programmed. If you now use the FORWARD or REVERSE
SEARCH controls, the player will advance or skip backwards through only the programmed tracks.
NOTE
YOU CANNOT SELECT THE PROGRAM FUNCTION IF THE RANDOM FUNCTION IS ENGAGED.
In case you forget which tracks have been programmed in the GCD-700’s memory, you can browse through the selections that
have been made using the remote control that was supplied with your player.
To browse through the memory, proceed as follows:
• Using the remote control, press the CALL button. Each time the button is depressed the display will show the track and
disc numbers stored in memory.
• When you are finished playing in the program mode and want to switch back to normal play, press the PROGRAM button
again or you can press the OPEN/CLOSE button. The LED in the center of the PROGRAM button will stop glowing,
indicating the player is no longer in the program mode.
REMOTE CONTROL TRANSMITTER RC-700CD
The controls on the remote control unit duplicate almost all the functions on the front panel of the GCD-700 and provide
additional controls not accessible from the front panel. Please refer to the diagram below of the RC-700CD to familiarize
yourself with its features. Be certain fresh batteries are installed in the unit before attempting to operate it.
(U