ASKO T731 - Manual (Page 11)

OPERATING INSTRUCTIONS
THE CONTROL PANEL
Power Button LED Window
Start Button
Stop Button
POWER BUTTON
The Power button turns the power to the machine on
and off. When the power is on, the power indicator light
glows red. The power must be on before you can start
the machine.
PROGRAM KNOB
Turn this knob to select a program. The programs are
described on the following page.
12:00 Position - This is where the line on the knob aligns
with the line above the knob. When the knob is in this
position, “00” displays on the LED to indicate no program
has been chosen.
LED WINDOW
The LED window displays the program number for the
Sensidry programs, as illustrated below:
(fPi t
The corresponding program numbers are:
Extra dry = PI Normal Dry = P3
Dry = P2 Iron Dry = P4
When you select Timed Dry, the LED displays the
number of minutes selected, plus the cool-down time,
as illustrated below:
(I 25»
When you select Air Fluff, the LED displays the number
ofminutes selected, as illustrated above. With both
programs 5 and 6, as the program advances, the LED
displays the remaining time.
“End” on the LED indicates the program is complete.
“C” indicates the program is in the cool-down cycle.
STARTBUTTON
After you have selected a program and the desired
options, press this button to start the dryer. The red
indicator light next to the Start button will come on. The
indicator light will go off when the program ends or has
been cancelled.
If you open the door during a program, the dryer will stop
tumbling automatically and the Start button indicator
light will blink. To continue the program, close the door
and press Start again. To cancel the program, press and
hold the Stop button until the Stop indicator light goes off
(approximately 3 seconds).
STOP BUTTON
You can interrupt a program by pressing and holding the
Stop button until the dryer stops. When you press Start,
the program will start from the beginning.
If you don’t want the program to restart from the beginning,
you can stop the unit by opening the door. If you stop the
dryer this way, when you press Start the unit will continue
from the point it was interrupted.
OPTION BUTTONS
The option buttons allow you to select program time,
normal or low temperature, anti-crease, delayed start,
buzzer and quick cooling. Each of these options is defined
in more detail in the following paragraphs.
t # me (3
If you set the program knob to Timed Dry or Air Fluff, you
must select the length of drying time by pressing this
button until the number of minutes you wish to dry the
load displays on the LED. The time advances in 5-minute
increments and you can select between 5 and 90 minutes.
If you pass the time you wanted to select, continue to
press the button until the correct time displays.
ATI-CREASE ^
The Anti-crease option prevents garments from wrinkling
if you’re unable to remove them right away. You can select
one, two, or three hours by pressing the Anti-crease
button until the number of hours you prefer displays, as
illustraed below:
NOTE:
active. “0” on the LED indicates the option is not
When you set a time, the drum will continue to rotate after
the program is complete for three seconds every minute
until the door is opened or the selected time (1-3 hours)
has passed. If the buzzer is on, it will sound each time
the anti-crease program activates.
Page 11