Error messages – ASKO T731 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ERROR MESSAGES
Error messages will display on the LED if a fault occurs
while a program is in progress. The table below defines
each possible error message. If the message still displays
after you have checked the possible solutions, call a
service technician.
MESSAGE
ERROR
FI
Call a service technician.
F2
There may have been a power outage. Check the breaker box and fuses.
The dryer is programmed to stop after a maximum of 3 hours drying time. If it has run this long,
let it cool and try to start the program again.
Try turning the power off then on again. If the message remains, call a service technician.
F3
This indicates a thermistor fault. Call a service technician.
F4
This indicates the overheat protection device has activated. Clean the lint filter and try running
the program again.
F5
This indicates a fault in the moisture sensor. Running a dry program with dry clothes or an empty
machine could also cause this error. Try opening the door. If the message remains, call a service
technician.
Page 15