Aiwa XR-M1000 - Manual (Page 26)

BASIC RECORDIN
This section explains how to record from the tuner, CD player, or
external equipment.
PAUSE I STOP
INSERTING BLANK SPACES
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function.
1 Press #REC/REC MUTE during recording or whiie in
recording pause mode.
The indicator on the #REC/REC MUTE flashes for 4 seconds
and the tape runs with no sound recording. After 4 seconds,
the deck enters the recording pause mode.
2 Press 11 PAUSE to resume recording.
To insert a biank space of iess than 4 seconds, press •
REC/REC MUTE again while the indicator on #REC/REC MUTE
is flashing.
To insert blank spaces of more than 4 seconds, after the deck
enters recording pause mode, press •REC/REC MUTE again.
Each time the button is pressed, a 4-second blank space is
added.
Preparation
• Use Type I (normal) and Type II (high/CrOa) tapes for recording.
• Set the tape to the point where recording will start.
1 Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing out
from the unit.
REJECT
2 Press REV MODE to select the reverse mode.
To record on one side only, select Z..
To record on both sides, select or CZ5.
3 Press DOLBY NR to turn Dolby NR on or off.
To record with DOLBY NR, turn on □□ NR.
To record without DOLBY NR, turn off □□ NR.
4 Press function on the stereo receiver (CD,
TUNER, VIDEO/AUX or MD) and prepare the
source to be recorded.
To record from a CD. press CD and load the disc(s).
To record from a radio broadcast, press TUNER and tune
in to a station.
To record from a connected source press VIDEO/AUX or
MD.
5 Press # REC/REC MUTE to start recording.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press BSTOP (or ■ CLEAR on the remote
control).
To pause recording, press IIPAUSE (or IISET on the remote
control). To resume recording, press it again.
Sound adjustment during recording
The output volume and tone (except BBE and Rhythm play
function) of the speakers or headphones may be freely varied
without affecting the recording.
About cassette tapes
• To prevent accidental erasure,
break off the plastic tabs
on the cassette tape with a screwdriver or other pointed
tool after recording.
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type II tapes, take care not to
cover the Type II tape detection slot.)
■ 120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
• Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism.
DOLBY NR system
The Dolby Noise Reduction system reduces tape hiss noise.
For optimum performance when playing back a tape
recorded with the DOLBY NR system, turn on the DOLBY
NR system.
26
ENGLISH