Autostart AS-2460 - Manual (Page 9)

Note: Once the Home Valet Mode is activated, the vehicle will not start by remote.
To take the system i n t o Home Valet Mode:
Press the lock button.
Within 3 seconds, press the start / stop and lock buttons simultaneously
until the Parking Lights go out.
To take the system out of Home Valet Mode:
Turn the ignition key to the ignition on ( run ) position.
The system will warn you if someone attempts to start your vehicle while it stands in Home Valet
Mode. The parking lights will:
Go on then off ; then
Flash twice, pause; then
Flash twice again.
Turbo Mode
If Turbo Mode is configured at installation, it will allow a turbocharger to idle down after the user
leaves the vehicle: the unit will take over the vehicle and keep it running for 60 seconds (or until it
is shut down by remote control), then shut down the engine and set the Remote Car Starter to
Ready Mode.
To activate Turbo Mode, follow all steps of the Ready Mode routine :
1. Ensure that all the doors are closed and that the shifter is in the neutral position.
With the engine already running, apply the parking brake and release the brake pedal.
Make sure to release the brake pedal.
Within 20 sec. press lock , unlock or start / stop on the transmitter.
The parking lights will flash 3 times quickly and remain lit.
Remove the key: the engine will go on running.
Exit the vehicle and close the door.
Press and hold either:
lock to lock the doors and shut down the engine after 60 sec.;
unlock to unlock the doors and shut down the engine after 60 sec.;
start / stop to shut down the engine immediately, without affecting the doors
(this will by-pass Turbo Mode).
trunk to set the vehicle into idle mode
Engine Run Time
If you have a gas engine, your Remote Car Starter can be programmed to run the engine for 3,15,
or 25 minutes (15 minutes by default). If you have a diesel engine, the Remote Car Starter can be
programmed to run the engine for 8,20, or 30 minutes (20 minutes default).
Fiashing LED
The user may decide to turn on or off LED flashing at any moment. To do so, press and hold the
lock and unlock buttons for 3 seconds:
Flashing LED on : the L.E.D. will flash at all times (either under active arming or under passive
arming) to indicate that the starter kill is active.
Active Arming: the LED will flash normally.
Passive Arming: the LED will not flash during the countdown preceding the activation of
the Starter Kill. Once the Remote Car Starter is armed, the LED will flash at a normal rate.
In Valet Mode: the LED will remain lit without flashing.
P. 12 User Guide
-The El icon will disappear from your LCD remote if you press lock or unlock .
Note: With the Ignition valet activated, the remote starter will be disabled.
Remote Valet Mode
This feature will allow you to remotely put your system into valet mode by using the transmitter
instead of the valet button as above.
Getting into vaiet mode
• Hold the H and ^ buttons simultaneously for 3 second.
• The parking lights will flash 3 times.
The LED will remain on solid.
— The Eicon will appear on your LCD remote.
Getting out of vaiet mode
+
• Hold the 11 and ~ buttons simultaneously for 3 second.
• The parking lights will flash 2 times.
The LED will turn off.
— The El icon will disappear from your LCD remote.
Note: With the remote valet activated, the remote starter will be disabled.
Panic Mode
In an emergency situation, you can activate panic mode by pressing and holding the lock or
UNLOCK button for 3 seconds. If the vehicle is under a remote start, the engine will shutdown
automatically before setting off the horn. You can stop the horn by pressing S (this will lock your
doors) or by pressing S (this will unlock your doors).
! buttons but it will not lock 5 or! If the car is not running, you can stop the horn by pressing the I
or unlock the doors.
Furthermore, the panic mode can be stop by activating one of the following three (3) features:
a) Remote valet (pressing H and ^ for 3 seconds)
b) Ignition valet (turning the key inside the ignition switch from off to on 5 times in a row)
c) Turn the key in ON position, then press the valet switch (if included).
Panic mode will automatically shut down after 25 sec.
Note: Panic mode can only be activated if the horn has been adequately configured by
your installer.
Quick Lockout TM
(Also called secure panic.) For fast protection in emergency situations, the system will lock all
doors when you press the brake pedal while you hear the sound signal. (Quick lockout is only
available when panic mode has been set off.)
Coid Weather Mode
When cold weather mode is active, the engine starts every 2 hours and runs for 3 minutes (or for 8
or 20 minutes with diesel engines). Cold weather mode automatically ends after 24 hours.
To enter Cold Weather Mode:
Press and release the E button and you will hear a beep, L-01 will appear on the display, then
press and hold the ^ button for 3 seconds until the parking lights flash three times.
The remote control will beep once and the (3 'con will appear on the display.
To exit Cold Weather Mode, do any one of the following actions:
• Cpen the hood.
• Start the engine by remote.
• Turn the ignition key to the
ignition on ( run ) position.
User Guide P. 9