Step 4 assemble pedals – BodyCraft Tour Trainer Indoor Cycle User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Advertising
STEP 4 ASSEMBLE PEDALS
1. Carefully align the thread of the axle on the Right Pedal (33)
("R" on end of axle) with the threaded hole on the Right Crank
Arm (35) and screw in clockwise by hand. Tighten the pedal to
the crank arm using a 15mm spanner. A little grease applied
on the threads should be helpful to screw in easily.
2. Repeat the same procedures to Left Pedal (34), but screw the
Left Pedal in counter- clockwise.
Tighten the pedal to the crank arm using the included 15mm
spanner wrench.
Advertising