Step 2 assemble handle bar and stem – BodyCraft Tour Trainer Indoor Cycle User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STEP 2 ASSEMBLE HANDLE BAR AND STEM
1. Insert the Stainless Steel Handlebar Stem (102) into the front tube on the
Bike Frame (97). Screw a Lock Lever (90) into the front tube.
2. Attach the Handlebar (103) to the slot in the Handlebar Stem (102) using
one Aluminum Washer (94) and one Lock Lever (90).
You can adjust the Handlebar (103) height and forward positioning
using the Lock Levers (90). Do NOT raise the Handlebar (103) above
the Safety Line! Make sure to
screw the Lock Levers (90)
103
tight to avoid slipping. If the
Lock Lever (90) hits a frame
piece, you can disengage the Lock
Lever (90) from the screw by
pulling on the spring loaded
Lock Lever Handle. Rotate the Lock
Lever (90) into a better position, then
release and resume tightening.
102