Step 3 assemble seat and seat post – BodyCraft Tour Trainer Indoor Cycle User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STEP 3 ASSEMBLE SEAT AND SEAT POST
Insert the Seat Post (99) into the rear tube on the
Bike Frame (97). Screw a Lock Lever (90) into the
rear tube.
101
100
99
94
90
-t!5d
2. Attach the Horizontal Seat Adjuster (100) to the Seat
Post (99) using one Aluminum Washer (94) and one
Lock Lever (90). Attach the Seat (101) to the
Horizontal Seat Adjuster (100) and tighten both nuts
located on the sides of the bracket on the Seat (100).
You can adjust the Seat height and forward
positioning using the Lock Levers (90). Do NOT
raise the Seat Post (99) above the Safety Line!
Make sure to screw the Lock Levers (90) tight to
avoid slipping. If the Lock Lever (90) hits a frame
piece, you can disengage the Lock Lever (90) from
the screw by pulling on the spring loaded Lock
Lever Handle. Rotate the Lock Lever (90) into a
better position, then release and resume tightening.