Want to change your mind, When the wash is finished, How to save energy – ASKO 1653 User Manual

Page 11: Seiect a program without drying heat, State and local sanitization codes and ruies, E3 zl j i im □ o

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Turn the control knob to either

Rinse and Hold or one of the

wash settings. The dishwasher

wiil start.

Main Power Indicator Light

sh

Main Wash

Rinses

Drying

------- 1 □ E3

Zl

J I IM

□ O

: Water is heated

to 170°F (74°C)

= You select Heat

or No Heat Dry

Want to change your mind?

If you want to change a program after you have started the machine,
select a new program by turning the program control.

If you want to stop the machine during a wash cycie

for instance in order to add more dishes

Press the door latch upwards. Then wait until the sound of circula­

ting water stops and the spray arms stop rotating. Then open the
door and add the forgotten item. Press the door closed completely.
The cycle will continue from the point where it was interrupted.

Items should be added during the prewash or as early as possible

during the main wash cycle for the best results.

If you turn off the machine at the main on/off switch

(or if there is a power failure) before the program has finished, the
program will continue when power is restored.

When the wash is finished

• When the machine has stopped, it consumes only an extremely

low current. To turn it off completely, turn off the main on/off
switch.

• The indicator light remains on as long as the switch is in the On

position. It is a good rule never to leave a switched-on machine
unattended.

• Empty the coarse filter and occationally check the fine mesh filter

if necessary.

How to save energy

Only start a wash when the machine

is compieteiy fuii

In order to save energy, it is best to wait until you have a full load

thus saving energy.

Seiect a program without drying heat

If you select a program without heated drying, the dishes will take

somewhat longer to dry. However, if you open the door during the
drying sequence to release the humid air the dishes will dry quicker.
(Note: Do not open the door during a heated dry cycle or the cycle

will be interrupted and the heating element will not come back on.)

State and local sanitization codes and ruies

You will find sanitization codes and rules available from your State Health Department. They will usually be found

in the Mechanical Cleaning and Sanitization section fo the Food Service or Food Sanitization Rules. Some states
have separate rules for Bed and Breakfast establishments. Be sure to check the rules for your particular
application. The rule will appear somewhat like this:

Machines using hot water for sanitizing may be used providing wash water and pumped rinse

water be kept clean and water shall be maintained at not less than the temperature stated in
this section of the rules.
a. Single-tank, stationary-rack, single temperature machine:

A. Wash temperature

165°F

B. Final rinse temperature

165°F

The 1653 has been designed to meet or exceed rules which require the above sanitizing standards for commer­
cial applications of dishwashers, these regulations may vary from state to state. Should you have any questions

regarding this unit meeting the requirements of a specific application, please consult your area Public Health

Department.

11

Advertising