Safety, Door switch, Level control – ASKO 1653 User Manual

Page 12: Child safety catch, This is how you engage the child safety catch, This is how you disengage the child safety catch, How to fit a new front panel, Lower panel, Upper panel

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Safety

Door switch

Level control

The machine is equipped with a door switch, breaking the current and internipting the
wash cycle if the door is opened while the machine is in operation. The door is also
equipped with a child safety catch (see text below).

Furthermore the machine is equipped with a level control (over flow), automatically starting

the drain pump should the water level reach a level higher than normal. This level control
functions only If the machine is in operation.

Child safety catch

The machine is fitted with a child safety catch to prevent children from opening the door

and risking injury from hot water or steam..ll also prevents children from getting at the
corrosive detergent, or sharp knives which may be inside.

o

This is how you engage the
child safety catch

Slide the catch to the left, then back­
wards and then to the right. To open the

door, hold the catch with your left hand
and pull the main catch with your right
hand in the usual way.

This is how you disengage the
child safety catch

Slide the catch to the left, then
fonvards and then to the right.

How to fit a new Front Panel

CAUTION! Turn the power supply to
the machine off first.

Lower panel

1. Undo the lower panel by unscrewing the attachment screws at the

bottom.

2. Remove the screws from the lower decor molding and loosen the

other screws. Remove the panel and replace it with the new one.

3. Screw the molding in position and tighten the remaining screws.

Fit the upper panel belore refitting the lower panel to the machine.

Upper panel

1. Remove the attachment screws and the molding on one side (ielt

or right).

2. Loosen the other screws and pull out the panel carefully.
3. Push in the new one carefully. Screw the molding in position and

tighten the other screws.

4. Refit the lower panel.

12

Advertising