DSC WLS900 - Manual (Page 13)

13
7 MASTER CODE FUNCTIONS
The Master Code is a unique personal Access Code that allows you to make changes to some of the
programming features in your system. In addition to arming and disarming the system, the Master Code
also allows you to:
• Set the Date and Time
• Enable and Disable the Door Chime Feature
• Add, Remove, and Change, Access Codes
• Replace System Components
• View Alarm History
• Perform a Walk Test of the System
Only the Master Code will allow you to change the functions listed above; normal Access Codes are not
able to change system features. When scrolling through the list of Master Code Function Menus, you
may press the
Key to return to the “System Ready” message.
To enter the Master Code Functions Mode, enter your master code and respond to each question until
the screen goes blank.
7A - Setting the Date and Time
Press the -YES Key to reset the Date and Time, or press the -NO Key
to display the next option. When the -YES Key is pressed, the following
message is displayed.
Using the Number Keys, enter the Date with 2 digits for the Month, 2 digits
for the Day and 2 digits for the Year. For example, the date of March 4 1996
would be entered as 030496. If an error is made in entering the Date, press
the
Key and the Keypad will display the “Reset Clock Y/N” message; press
the -YES Key and enter the correct Date. When the complete Date is
entered, the next message will be displayed.
Using the Number Keys, enter the Time in using the 24-hour clock format. For
example, the time 1:15 pm would be entered as 13:15. If an error is made in
entering the time, press the
Key and the Keypad will display the “Reset
Clock Y/N” message; press the -YES Key and re-enter the correct Date
and then the Time. After the Time is entered, the next message will be
displayed.
The Date and Time you have just entered will be displayed on the screen; in
this example, the Date is March 4 1996, and the Time is 1:15 pm. If a mistake
has been made in entering the Date or Time, press the
-YES Key to re-
enter the Date and Time as described above. If the Date and Time are
correct, press the
-NO Key to enter the next Master Code Function.