DSC WLS900 - Manual (Page 5)

5
The Improper Arming is designed to prevent false alarms by warning you when your system has been
improperly armed. If a Zone, such as Door or Window Sensor, is left open when the system is armed, an error
tone will sound. The error tone will sound for the duration of the Entry Delay time. If the system is not disarmed
before the Delay expires, an alarm will be reported to your monitoring station.
3D - Arming the System in the Home Mode
The Keypad will normally be in an inactive state to conserve its batteries.
Press
and the Keypad will wake up.
Enter your personal Access Code using the Number Keys. As each digit of
the code is entered, an “X” will appear on the Keypad screen. If a mistake
is made while entering your personal Access Code, press the
Key to clear
the mistake and re-enter the Code again.
If the system is ready to be armed, this message will be displayed for a few
seconds. After a few seconds, the next message will be displayed. If the
system is, “not ready to be armed
not ready to be armed not ready to be armed not ready to be armed not ready to be armed”, or if there are conditions on the system
of which you should be aware, other messages may be displayed; refer to
Section 5 of this manual for further discriptions.
To arm the system in the Away Mode, press the - YES Key when this
message is displayed. To display the next message or to arm the system in
the Home Mode, press the
-NO Key.
To arm the system in the Home Mode, press the - YES Key when this
message is displayed. If the system is armed in Home Mode, only some
of the sensors in your system will be active when the system becomes
armed.
This option is designed to allow you to remain on the premises while
the system is armed. Zones that cover the interior of the premises will not
cause an alarm if activated, but zones that cover most entry points, such as
windows and doors, will sound an alarm if they are activated. Your installer
will tell you which zones are automatically bypassed when the system is
armed in the “Home Mode
Home Mode Home Mode Home Mode Home Mode”. When this message is displayed, press the -
YES Key to arm the system in the Home Mode. If you want to bypass zones,
press the
-NO Key.
When the - YES Key is pressed to arm the system in the “Home Mode Home Mode Home Mode Home Mode Home Mode”,
this message may be displayed. To arm the system and enable the Entry
Delay, press the
- YES Key. With the Entry Delay turned on, activating an
Entry/Exit Zone will start the Entry Delay. When the Entry Delay begins, a
personal Access Code must be entered to disarm the system. To arm the
system with the Entry Delay turned off, press the
-NO Key. With the Entry
Delay off, activating an entry zone will sound an alarm immediately.
When the - YES or -NO Keys are pressed, the Exit Delay will begin
and this message will be displayed for a few seconds. With 30 seconds
remaining in the Exit Delay, the Sounder will begin to “beep” once every
second. During the last 10 seconds of the Exit Delay, the Sounder will “beep”
twice every second. At the end of the Exit Delay, the Sounder will be silenced
and the system will be armed. If you have not left the building, you must
disarm and then re-arm the system.