DSC WLS900 - Manual (Page 7)

7
When scrolling through the Alarm Memory Display, the screen will display
messages like the one shown here. The Zone that went into alarm will be
displayed, along with a message asking if you would like to view the next item
in the list. Press the
-YES Key to view the next Zone in Alarm Memory, or
press the -NO Key to return the Keypad to its inactive state. When the last
Zone in Alarm Memory has been displayed, pressing either the -YES or
-NO Key will return the Keypad to its inactive state.
4D - Alarm Memory and Alarm History
Alarm Memory provides a record of Zones that went into alarm during the time the system was armed.
The next time you arm the system, the Alarm Memory will be cleared and the events in Alarm Memory will
be recorded in Alarm History. Any old events in Alarm History will be cleared when Alarm Memory is
recorded as Alarm History.
Alarm History retains a record of Zones that appeared in Alarm Memory. When Alarm Memory is
cleared, Alarm History will record the Zones that had been displayed as Alarm Memory. You can
refer to Alarm Memory and Alarm History to determine if certain Zones repetitively sound alarms.
Refer to “Viewing Alarm History” in the System Status Messages, Section 5J of this manual for
information on viewing Alarm History.
When Alarm Memory and Alarm History are viewed, the Keypad will display
the Zone Labels for the zones that went into alarm. The example here shows
Zone 1 went into alarm. Press the
-YES Key to view other zones that went
into alarm.
Alarms activated by pressing the , or Keys on the
Keypad will be indicated with messages similar to the one shown here.
4E - Quick Exit Feature
The Quick Exit feature is designed to allow you to exit the premises without sounding an alarm while the
system is armed. This feature must be enabled by your installer before it may be used. Your installer will
tell you if this feature has been enabled on your system.
With the system armed, enter your personal Access Code. The Keypad will
display a message similar to the one shown here.
When the Keypad displays this message, press the -NO Key. When you
press the -NO Key, the next message will be displayed.
Press the -YES Key to activate the Quick Exit feature. When Quick Exit
is activated, you will be allowed up to two minutes to exit the premises. During
the two minute period, you may exit the premises through the designated
Entry/Exit door.
You may activate the Entry/Exit Zone only once; re-entering will start the Entry Delay.