Chapter 5: dvr setup – Q-See Q25DVR4ES User Manual
Page 15
Advertising
Q-See Q25DVR4ES User’s Manual
Page 15
Change the J10 jumper on the system board to select NTSC or PAL video output as
marked on the silkscreen of the system board.
Press the
[ SEL] Button to reload factory defaults, then the DVR will reboot, all
custom settings (including password) will be restored to default.
There is no confirming dialog box for this selection after you press [
SEL]
button, the system will just reboot!
Chapter 5: DVR Setup -
5.15 NTSC/PAL Output Selection
Chapter 5: DVR Setup -
5.16 Factory Reset
NTSC/PAL Select
Advertising