Acreative 820HD User Manual
Page 5
-3-
Telescoping Whip Antenna
The telescoping whip antenna provides good reception
and can be easily adjusted. With adjustment factored in, it
may perform the best of the three antennas.
Once properly installed, the telescoping whip antenna will
remain at any position you place it.
To Install:
a) Push the end of the antenna with the nut onto the FM
connector.
b) Slip the supplied wrench around the antenna and slip
it up against the nut end of the whip antenna. The wrench
flanges will be close to touching the back of the radio
when you have successfully slipped it onto the antenna
nut.
c) Tighten the antenna nut securely.
d) Remove the wrench, then push the antenna upright.
Extend the whip antenna, then adjust for best reception
on a particular station, as required.
Note:
For FM stations below 94 mHz, the antenna will always
perform best if fully extended. Stations above 98 mHz may
benefit from a reduction in length of up to 2-3 inches.
a)
b)
c)
d)