Dolby Laboratories 6000 - Manual (Page 27)

-26-
XI. TROUBLESHOOTING
If you experience the following problems while using the
unit, this troubleshooting guide can help you.
No sound
Check if the unit is connected securely.
Make sure you operate the TV or amplifier correctly.
Make sure you have selected HDD video recorder
position on the amplifier.
No image
Check if the unit is connected securely.
Make sure you operate the TV correctly.
Make sure you set the colour system correctly.
Bad sound quality
Make sure the audio output mode is set correctly.
Make sure the audio connection between the unit
and amplifier is right.
Image rolls and no colour
The colour system set by this unit does not match
with that of TV. Push P/N on the remote control to
select needed one.
Disc cannot be played
There is no disc in the unit.
Put the disc on the disc tray properly with the label
side up.
Clean the disc.
Moisture has condensed in the unit. Remove the disc
and leave the unit on for about one hour.
Remote control does not work
Remove barriers between the remote control and the
unit.
Replace the batteries with new ones.
Point the remote control at the remote control sensor
of the unit.
Reference page 2.