Daxten Voyager 300 - Manual (Page 8)

8
The Quick system guide illustrates how the units are interconnected .
1. Switch off your PC
2. Connect the local Voyager, keyboard, monitor and mouse as shown in the
appropriate diagram (page 8). You can use the local without mouse, keyboard
and monitor.
3. Connect the UTP cable between the local and remote
4. Connect the mouse keyboard and monitor to the remote.
5. Power up the Remote Unit by connecting the supplied mains adapter and
switching it on.
6. Power on your PC and operating system
7. Check keyboard operates correctly.
8. Check that the mouse functions works right
9. The Remote Unit contains video equalisation circuitry that compensates for loss
in image quality experienced when driving over long cables.
To set the correct level of equalisation there are two adjustments on the front
side of the remote unit . adjust the distance appropriate to the cable length
adjust the Eq. Fine tune the distance again.
Distance Eq.
Cable Length (m) Cable Length
(ft)
LED
0 – 100 m 0-350 No light
80-220 m 250-725
LED 1 ON
190- m 600-
LED 2 ON
Cable Length distance Setting
The remote unit (when installed in its final location) may be left permanently powered
up.
Please note that for all practical purposes cable equalisation cannot be exact - the
remote image will never be as sharp as the original.
To make the distance setting easy as possible we have incorporated distance setting and
three boost steps. It means that you will feel a big gain jump when the LED’s change.
If you are in the changing area try adjust the EQ level before and after the LED’s has
changed distance area to achieve the best picture.
If you are dealing with CAT6 and cables under 100 meters the local can be modified to
get an even better picture.
The LED’s are guidelines because cables differ in quality
Adjust the Distance afterwards the Equalizer EQ,
CONNECTING UP