Acrosser AR-B5495 - Manual (Page 16)

12
Installing the Motherboard
DDR2 SDRAM memory module table
Installing Memory Modules
This motherboard accommodates one memory module. It can support one 240-pin
DDR2 533/400. The total memory capacity is 2 GB.
Do not r emove any memory module fr om its antistatic packaging
until you are ready to install it on the motherboard. Handle the
modules only by their edges. Do not touch the components or metal
parts. Always wear a grounding strap when you handle the modules.
Installation Procedure
Refer to the following to install the memory modules.
1 This motherboard supports unbuffered DDR2 SDRAM .
2 Push the latches on each side of the DIMM slot down.
3 Align the memory module with the slot. The DIMM slots are keyed with
notches and the DIMMs are keyed with cutouts so that they can only be
installed correctly.
4 Check that the cutouts on the DIMM module edge connector match the
notches in the DIMM slot.
5 Install the DIMM module into the slot and press it firmly down until it
seats correctly. The slot latches are levered upwards and latch on to
the edges of the DIMM.
DDR2 533 266 MHz
Memory module Memory Bus
Installing Hardware
DDR2 400 200 MHz