ADLINK cPCI-7249R - Manual (Page 20)

12 • Installation
CompactPCI Installation Procedures
1. Read through this manual, and setup the jumper according to your
application.
2. Turn off your computer and turn off all accessories connected to
computer.
3. Remove the slot cover from the CompactPCI.
4. Select a 32-bit CompactPCI slot on the back plane for cPCI-7248 board.
Select a 32-bit CompactPCI slot with rear I/O extension for cPCI-7249R.
5. Before handling the boards, discharge any static buildup on your body by
touching the metal case of the computer. Hold the edge and do not touch
the components.
6. Position the board into the slot you selected.
7. Secure the card on the back plane by using screw removed from the slot.
8. Install the rear I/O transition board for cPCI-7249R.
2.5 Device Installation for Windows Systems
Once Windows 95/98/2000 has started, the Plug and Play function of
Windows system will find the new NuDAQ/NuIPC cards. If this is the first time
to install NuDAQ/NuIPC cards in your Windows system, you will be informed
to input the device information source. Please refer to the “Software
Installation Guide” for the steps of installing the device.