American Sanders OBS 18DC Orbital Sander - Manual (Page 5)

EN ENGLISH
Clarke ® American Sanders Operator's Manual (EN) - OBS-18/18DC -5-
Figure # 3
Machine Setup
To prepare the machine for use follow this procedure:
1. Familiarize yourself with the machine. Read all danger,
warning, and caution statements and the Operation and
Parts Manual before operating the machine. If you or the
operator are unable to read English, have this manual fully
explained before attempting to operate this machine.
2. Install or replace pad. The pad should be replaced if it has
become matted down to a thickness of 3/8” or less. To
install or replace the pad, follow these instructions:
a.) Lock handle in the upright position.
b.) Tilt the machine back until it fully rests on the handle.
c.) Standing over the machine, remove existing pad
then center new pad over grip face.
d.) Press pad against grip face until the hooks in the
driver have set in the pad. See figure 3.
e.) Return machine to the upright position.
CAUTION: Damage to the grip face will occur if the
machine is operated without a pad or with
a pad that is 3/8” or thinner.
WARNING: Never put yourself or let others be in
a position to get injured if the machine
should tip or fall, while replacing the pad or
changing abrasive.