Angelcare AC1120 - Manual (Page 11)

1.4 TEMPERATURE
the baby’s room temperature is always indicated on the
top bar of the screen. By setting the temperature alarm,
you will be alerted if the room temperature is too cold or
too hot. if the temperature that you have set goes out of
range, 4 consecutive beeps will be heard every 4 seconds
and the temperature alarm icon will be displayed in the
center of the lCd screen.
press on the therMoMeter icon on the MAin MenU,
then press the “+” and “-” for the temperature settings.
1. Maximum temperature is between : 15 and 32°
Celsius / 59 and 90° fahrenheit.
2. Minimum temperature is between : 5 and 20° Celsius/
41 and 68° fahrenheit.
3. the range between the minimum and maximum
temperature is 4° C / 7° f. An error tone will be heard
if you try to set it up below this range.
4. press key at the left bottom corner of screen to switch
the temperature scale to fahrenheit or Celsius. the
scale you selected will be indicated above the key.
5. if the temperature alarm is set on, the word “on” will
appear above the alarm icon and the thermometer
will appear on top of the video screen bar.
6. press oK to confirm setting.
Note: if the temperature goes below 0°C (32°f) or over
45°C (113°f) the top bar will display LO (low) or HI (high)
instead of the room temperature.
teMperAtUre AlArM
iCon
teMperAtUre
iCon
to start the tiMer, press the tiMer icon located on the
MAin MenU.
1. the screen will display the baby’s room and the timer.
2. the timer runs from 0:00 (0 hours and 00 minutes) to
a maximum of 5 hours and 59 minutes.
3. After showing “5:59”, it will then stop automatically
and disappear from video display.
Note: when parents Unit is turned off, the timer will
automatically reset and turn off.
1.3 TIMER
tiMer iCon tiMer displAy
Degrees can be shown in
Farenheit or Celcius.
11
AC1120 UK A5 05.15.2012 12-05-15 8:12 AM Page 11