Angelcare AC403 - Manual (Page 4)

Keep
at least
1 m
IMPORTANT
6
5
4 3 2 1
IMPORTANT
Place the crib near a supporting wall and
far from air currents. Install the Nursery
Unit on a flat, stable surface facing the crib
at a distance of at least 1 meter.
16.11 If and when necessary, the batteries
must be replaced with identical new ones
or equivalent (volts and size). If a battery to
be replaced is connected with other batteries
in series, replace the other batteries at the
same time as well. DO NOT mix old and
new batteries.
16.12 Reverse polarity installation of the
batteries in the end product must be
avoided. Reverse insertion of batteries
can cause charging, and that may result
in leakage or explosion.
16.13 Remove batteries from this product
if you store the product over 30 days
because the batteries could leak and
damage the product.
16.14 Discard ‘dead’ batteries as soon as
possible since ‘dead’ batteries are more
likely to leak in a product. If a battery has
leaked or vented, it should be replaced
immediately using protective gloves.
16.15 DO NOT store this product, or the
batteries provided with or identified for
use with this product, in high-temperature
areas.
WARNING
(North America Only)
17.1 Modifications not authorized by the
manufacturer may void users authority to
operate this device.
17.2 NOTE: This equipment has been
tested and found to comply with the limits
for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates, uses
and can radiate radio frequency energy
and, if not installed and used in accordance
with the instructions, may cause harmful
interference to radio communications.
17.3 However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment OFF and ON, the
user is encouraged to try to correct the
interference by one or more of the following
measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between
the equipment and receiver.
• Connect the equipment into an
outlet on a circuit different from that
to which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
17.4 This device complies with part 15 of
the FCC Rules. Operation is subject to the
following two conditions:
(1) This device may not cause harmful
interference, and
(2) This device must accept any interference
received, including interference that may
cause undesired operation.
YOU MUST PREPARE:
One hardboard (not included)
Thickness:
6 mm
Minimum dimensions:
33 cm x 33 cm
Maximum dimensions:
equal to the mattress size
WHAT YOU WILL NEED (NOT INCLUDED):
1 Parent Unit (AC403) or
2 Parent Units (AC403-2PU
and AC403-2PU-2SP)
2 AC Adapters (AC403) or
3 AC Adapters (AC403-2PU
and AC403-2PU-2SP)
Nursery Unit 1 Sensor Pad (AC403) or 2 Sensor Pads
(AC403-2PU-2SP) with pre-installed cord covers
3 Rechargeable AAA Batteries (AC403) or
6 Rechargeable AAA Batteries (AC403-2PU
and AC403-2PU-2SP)
4 AAA Alkaline
Batteries
for Nursery Unit
MOVEMENT &
SOUND MONITOR
Model AC403
IMPORTANT
The hardboard must be larger than the
Sensor Pad surface area or in the case of the
AC403-2PU-2SP of two Sensor Pads.
Sensor Pad
BABY’S ROOM:
SETUP REQUIREMENTS
4X
3X
INCLUDED:
Miniature Philips
Screwdriver
FCC AND IC REGULATIONS
RF radiation exposure statement
The Nursery Unit complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. Caution: To maintain the compliance with the FCC’s RF exposure guideline, install
the Nursery Unit at least 20 cm from from ALL persons. The transmitter of this device must
not be co-located or operating in conjunction with any other antenna or transmitter.
Industry Canada
This product meets the applicable Industry Canada technical specifications.
CAN ICES-3 (B)/NMB-3(B)
2X
6 5 4 3 2 1
Hardboard
7 6