AutoPage C3-RS915LCD - Manual (Page 10)

C3 RS915 REV. O1 10
3. While the LED is illuminated, press any button on the remote control transmitter to control a second vehicle
security system.
4.
For LCD transceiver – 2 nd
car operation :
a. Press and hold
F
button of LCD remote for 1 second until 2 beeps sound and then release the
F
button.
b. The text
will flash on the LCD screen, press button to enter the menu.
c. Press or button to move up or down in the menu, find CAR SELECT on the menu.
d. Press button to select the option you would like to adjust CAR 1 or CAR 2 for further operation.
Caution: If the LCD transmitter does not function. Please insure it is set to operate car #1
X. Clear the Flash Icon and Melody Sound: The Transmitter will reset the flashing icons
the next time the Ignition is cycled to the ON position.
Y. Stop The Trigger Melody Sound: While triggering the alarm the LCD screen will alert the user
through a melody sound and a flashing trigger icon. Press any button on the LCD remote transmitter to stop
melody sound only.
Z. Vibration / Melody Mode:
(see advanced users menu for more info)
Press and hold the
F
button until 2 beeps are heard. You will see the word .Press the trunk button to
scroll through the menu. Scroll to the word “ Vibrate”. When you see the word “Buzzer Vibrate”,
press the trunk button once to enter programming. Press the button to change the setting. (Buzzer, BZ VIB,
Vibrate). Once a setting is chosen. Press the button to confirm.
REMOTE START OPERATION:
A. TO REMOTE START THE VEHICLE:
When you want to start your vehicle,
1. Press
button once on the transmitter.
2. The parking light will activate to indicate the remote start received the signal.
3. The engine will start in approximately 5 seconds.
4. Once the engine is running, after couple seconds the parking lights will turn on and the climate
controls will activate and adjust the vehicle’s interior temperature to your preset setting. (While the
vehicle is running, the “minutes” digit on the LCD screen will flash and the will indicate countdown
timer based on the 5, 10, 20 or 30 minute run time set up by your installation center.)
5. The vehicle will run for a programmable 5 to 30 minute cycle before shutting down. (When the
unit shuts off the countdown timer will turn off and the transmitter will play a melody.)
NOTE: The Remote Start Unit will not start the vehicle if any one of the following conditions
exists:
1. The hood is opened.
2. The brake pedal is pressed.
3. The optional remote start enable toggle is switched to the “OFF” position. (If installed)
4. The gear selector is in any gear other then “PARK” or “NEUTRAL”.
SAFE START (Child safety mode)
Factory default is set to press the button once on the transmitter to start the vehicle. You can program this
feature to eliminate an accidental remote start:
1. The user presses the transmitter buttons twice within 3 seconds to start the vehicle. or
2. The user presses the transmitter and buttons at the same time to start the vehicle.
NOTE: Contact your installing dealer to activate this feature.
B. OPERATE THE VEHICLE WHILE RUNNING FROM THE REMOTE START:
To operate the vehicle while the engine is running from the remote start,
1.
Insert the ignition key and turn it to “ON” (not the start) position.