AutoPage C3-RS915LCD - Manual (Page 9)

C3 RS915 REV. O1 9
R. IGNITION CONTROL DOOR LOCK/UNLOCK. (Programmable Feature)
If the vehicles door locks have been interfaced to the security system, the system will automatically lock the
vehicle's doors when the ignitio
n is turned “ON” and /or unlock the vehicle’s doors when the ignition is turned
“OFF”. (Default setting is “OFF”)
S. TRUNK RELEASE (CHANNEL 3) OUTPUT.
Press and hold button on the transmitter for two seconds to remotely control the trunk release.
T. CHANNEL 4.5.6 TIMER CONTROL OUTPUT.
CHANNEL 4 TIMER CONTROL OUTPUT.
Press the transmitter and buttons at the same time to active Channel 4 function. or
Press and hold
F
button of LCD remote until 2 beeps sound , release and re-press
F
button the
LCD remote will show “CH 4” icon flash, then press
button to activate channel 4 function.
Channel 4 is user-programmable timer output. You may program the built-in timer to send a ground signal for
any time duration from 1 second to 120 seconds. For instance, this timer output may be used to turn on the
headlight, power window or sunroof. (Factory defaults setting at momentary output.)
CHANNEL 5 TIMER CONTROL OUTPUT.
Press the transmitter and buttons at the same time to active Channel 5 function. or
Press and hold
F
button of LCD remote until 2 beeps sound , release and re-press
F
button the
LCD remote will show “CH 5” icon flash, then press
button to activate channel 5 function.
Channel 5 is user-programmable timer output. You may program the built-in timer to send a ground signal for
any time duration from 1 second to 120 seconds. For instance, this timer output may be used to turn on the
headlight, power window or sunroof. (Factory defaults setting at momentary output.)
CHANNEL 6 TIMER CONTROL OUTPUT.
Press the transmitter and buttons at the same time to active Channel 5 function. or
Press and hold
F
button of LCD remote until 2 beeps sound , release and re-press
F
button the
LCD remote will show “CH 6” icon flash, then press
button to activate channel 6 function.
Channel 6 is user-programmable timer output. You may program the built-in timer to send a ground signal for
any time duration from 1 second to 120 seconds. For instance, this timer output may be used to turn on the
headlight, power window or sunroof. (Factory defaults setting at momentary output.)
U. POWER SAVER MODE (Default OFF) * See advanced user mode
Under Menu mode press button while “POWER SAVE” icon flash, press button Power save
ON, while the power save mode, the LCD remote transceiver use “0” current to save the battery power.
Press button Power save OFF
Exit: Press any button of the LCD remote transmitter to exit “Power Save Mode”.
V. POWER ON MEMORY:
This security system is equipped with circuitry that will allow the unit to remember its alarm state if
the power is lost and then reconnected.
W. SECOND VEHICLE SECURITY OPERATION:
Your 5-button remote transmitter can be utilized to control a second vehicles security system, To program the
remote control transmitter to a second vehicle, follow the instructions for Transmitter programming.
* For the standard transmitter (
II) is shift button.
Standard Transmitter
1. Prior to pushing any button on the transmitter. Press the Select
II button first on the transmitter.
2. Once
II button is pressed the LED on the transmitter will illuminate for 3 seconds to indicate the second
transmitter pin code has built-in.